Skip to content
Vandiver Heating & Air
A new tank water heater on a drain pan with copper connections, an expansion tank above and the relief line piped down.

Installation

Water Heater Installation in Woodstock, GA

Most water heater replacements happen the same day the old one fails, which means most people make the decision standing in a wet basement. We keep standard sizes on the truck, we pull the permit, and we bring the new one up to current code on venting, expansion, and drain pan — which the twelve-year-old one usually is not.

What's included

  • Old tank drained, disconnected and removed
  • Expansion tank fitted and pre-charged to your actual static pressure
  • Temperature and pressure relief valve with a full-size discharge to a safe termination
  • Drain pan and pan drain where the location calls for one
  • Venting brought to current code — material, rise, connector slope, and clearances
  • Sediment trap and shutoff on the gas line, or the disconnect and bonding on an electric unit
  • Water heater strapped, levelled, and set to a sensible delivery temperature
  • Permit pulled and the old tank hauled away

How the visit actually goes

  1. We ask what failed, because it changes the answer

    A leak at the tank seam is a replacement. A leak at a fitting, a failed element, or a bad thermocouple is not. If you call us at eight in the morning with water on the floor we will ask you three questions that decide which conversation we are about to have.

  2. We size it to the household, not to the old sticker

    The tank that was right for the family who built the house may not be right for yours, in either direction. First-hour rating and recovery matter more than nominal gallons, and an oversized gas tank in a small utility closet brings its own venting problems.

  3. Replacement, usually the same day

    Standard sizes are on the truck. Out with the old, in with the new, and the code items that were missing on the old install go in as part of the job rather than as an upsell at the end.

  4. Fill, purge, test and check the combustion

    Purge the air, check for leaks under pressure, verify the relief discharge, confirm draft on a gas unit, and take a carbon monoxide reading before we leave. The permit inspection follows.

What the warranty actually covers

Cheryl files the manufacturer registration within 48 hours of every install we do, and you get the confirmation. We do that because the length of the parts coverage turns on it, and a system registered late is a system with a fraction of the coverage its owner thinks it has.

Warranty length depends on registration within roughly 60 days. The warranty is the manufacturer's, not ours. Full terms

About efficiency ratings

We will tell you the rating on any equipment we quote, and we will tell you what it is measured under. What we will not do is convert it into a number of dollars for your house. The variables that decide that — duct leakage, insulation, how you actually run the thermostat, and the weather — are all larger than the difference between two ratings, and we would be guessing at every one of them.

Ratings are federal test-procedure figures. Actual savings vary with the house. Full terms

Members skip the diagnostic fee.The Comfort Club

Questions people ask before booking

  • Can you do it today?

    Often, yes — standard tank sizes are on the truck and a straight replacement is a few hours. A tankless conversion, an attic install, or a unit that needs the venting rebuilt is scheduled rather than same-visit.

  • What changes the price?

    Tank size and fuel, whether the code items are already there or have to be added, venting condition, access, and whether the shutoff and gas line are usable. We give you the number before we start rather than after we have your old tank on the truck.

  • Do I really need the expansion tank?

    If your house has a backflow preventer or a pressure-reducing valve — most in this area do — then yes. The plumbing becomes a closed system, and heated water that has nowhere to expand pushes on the relief valve until it starts weeping. That is the leak people mistake for a failing tank.

  • Do I need a permit?

    Yes, and it is included. Water heater replacement is permitted work in every jurisdiction we cover.

  • What does the warranty cover?

    The tank and parts warranty is the manufacturer's and depends on registration inside the window. The full condition is set out below.

Available across 10 towns in Cherokee County and the north metro. See where we work.

Book this service

  1. 1. What's going on
  2. 2. Where
  3. 3. You
What is happening, and how urgent it is
What's going on? (required)
Which system? (required)
Is this an emergency? (required)
Call (770) 555-0187Book a service call